Clearing Diagnostic Trouble Codes

NOTE: This is the only information provided by the manufacturer for clearing diagnostic trouble codes.

Erasing the DTC Memory

Special Tools Required
SCS Service Connector 07PAZ-0010100

To erase the DTC(s) from the SRS unit, use a Honda PGM Tester (see the Honda PGM Tester SRS Vehicle System Supplement) or the following procedure.

1. Make sure the ignition switch is OFF.

Left Side Of Dash, Above Kick Panel, Behind Knee Bolster.:

2. Connect the SCS service connector (A) to the MES connector (2P)(B). Do not use a jumper wire.
3. Turn the ignition switch ON (II).
4. The SRS indicator light will come on for about 6 seconds, and then go off. Remove the SCS service connector from the MES connector (2P) within 4 seconds after the light goes off.
5. The SRS indicator light will come on again. Reconnect the SCS service connector to the MES connector (2P) within 4 seconds after the light comes on.
6. When the SRS indicator light goes off, remove the SCS service connector from the MES connector (2P) within 4 seconds.
7. The SRS indicator light will blink two times indicating that the memory has been erased.
8. Turn the ignition switch OFF, and wait for 10 seconds.
9. Turn the ignition switch ON (II) again. The SRS is OK if the SRS indicator light comes on for 6 seconds, and then goes off.