With Manufacturer's Scan Tool

How to Retrieve ABS DTCs





1. Connect the Honda PGM Tester (A) to the 16P Data Link Connector (B) located behind the driver's side kick panel with the ignition switch OFF.
2. Select "SCS" on the display of the Honda PGM Tester, then push "YES" at the "SERVICE CHECK SIGNAL" mode.
3. Turn the ignition switch ON (II) without the brake pedal pressed.

NOTE: If the brake pedal is pressed when turning the ignition switch ON (II), the system shifts to the MES mode.





4. The blinking frequency indicates the DTC.

NOTE: If the DTC is not memorized, the ABS indicator will go off for 3.6 seconds, and then come back on.

The system will not indicate the DTC unless these conditions are met:
- Vehicle speed is 6 mph (10 km/h) or less.
- SCS circuit is shorted to body ground before the ignition switch is turned ON (II).
- The brake pedal is released.
5. Turn the ignition switch OFF.
6. Press "EXIT" on the Honda PGM Tester.
7. Disconnect the Honda PGM Tester from the 16P Data Link Connector.