Set/Resume/Cancel Switch

1. Disconnect the battery negative cable, then disconnect the positive cable, and wait at least three minutes.
2. Disconnect the driver's airbag and front passenger's airbag connectors.
3. Remove the dashboard lower cover and knee bolster.




4. Disconnect the 6P connector between the cable reel sub harness and the main wire harness.




5. Check for continuity between the terminals of the 6P connector in each switch position according to the table.
- If there is continuity, and it matches the table, the switch is OK.
- If there is no continuity in one or both positions, go to step 6.




6. Remove the two screws, then remove the switch.




7. Check for continuity between the terminals in each switch position according to the table.
- If there is continuity, and it matches the table, replace the cable reel.
- If there is no continuity in one or both positions, replace the switch.

8. If all tests prove OK, reconnect the cable reel sub-harness connector.
9. Reconnect the driver's airbag and front passenger's airbag connectors, and reinstall the access panel on the steering wheel.
10. Reconnect the battery' positive cable, then the negative cable.
11. After connecting the airbag connectors, confirm proper system operation: Turn the ignition switch ON (II); the SRS indicator light should come on for about six seconds and then go off.