Guide Rails/Cable Assembly Replacement

Guide Rails/Cable Assembly Replacement

CAUTION: Put on gloves to protect your hands.

1. Remove the frame.
2. Remove the motor and glass bracket.

3. Remove the nuts, and lift off each guide rail, then remove the cable assembly with sliders attached.

NOTE: Take care not to bend the cable tubes and guide rails.





4. Installation is the reverse of the removal procedure.

NOTE:
- Damaged parts should be replaced.
- Grease the sliding portion with Super High Temp Urea Grease, PIN 08758-9002.





- Fill the groove in each grommet with sealant.
- Install the frame seal securely.
- Before installing the motor, make sure both sliders are parallel.
- Before installing the motor, install the frame and glass, then check the opening drag. Open Drag Check