Steering Column Removal

Steering Column Removal

Steering Column / SRS Main Connector / Cable Reel Connector:

CAUTION:
- Before removing the steering column, first disconnect the connector between the cable reel and the SRS main harness.
- If the steering column is going to be removed without dismounting the steering wheel, lock the steering by turning the ignition key to O-LOCK position, or remove the key from the ignition switch so that the steering wheel will not turn.

NOTE:
- When the airbag and cable reel are disconnected, don't reconnect the battery cable. If the battery is reconnected and the ignition switch is turned ON (II), the SRS unit will store this as an open in the driver's airbag inflator, and the SRS indicator light will come on.
- For disconnecting the spring-loaded lock type connector, refer to Spring-loaded Lock Connector & Spring-loaded Lock Connector with Built-in Short Contact.

Do not replace the original steering wheel with any other design since it will make it impossible to properly install the airbag (only use genuine Honda replacement parts).

After reassembly, confirm that the wheels are still turned straight ahead and that the steering wheel spoke angle is correct. If minor spoke angle adjustment is necessary, do so only by adjusting the tie-rods, not by removing and repositioning the steering wheel.