Lateral G Sensor

CAUTION: Be careful not to drop or bump the sensor, and don't remove or install it with an impact wrench; the sensor may be damaged.

NOTE: For accurate readings, the vehicle must be level.

1. Remove the SRS unit.
2. Turn the ignition switch ON (II).





3. Measure the voltage between the acceleration sensor connector terminal No. 2 and body ground. There should be approx. 2.5 V.





4. Remove the lateral G sensor.





5. Measure the voltage between the lateral G sensor connector terminal No. 2 and body ground with the connector connected.
6. There should be approx. 1.5 V when the connector side facing up.
7. There should be approx. 3.5 V when the connector side facing down.