Trunk / Liftgate Weatherstrip: Service and Repair

Hatch Weatherstrip Replacement

1. Remove the hatch support strut from each side of the body.




2. Remove the hatch weatherstrip (A) by pulling it off.
3. Apply clear sealant (B) into the groove of the hatch weatherstrip all the way around.

Sealant: Cemedine P/N 08712-0004, or equivalent

4. Locate the painted alignment mark (C) on the hatch weatherstrip. Align the painted mark with the alignment tab in the center of the hatch opening, and install the weatherstrip all the way around in the direction shown. Make sure there are no wrinkles in the weatherstrip.
5. Reinstall the hatch support struts.
6. Check for water leaks.