Brake Pad: Testing and Inspection
Front Inspection and ReplacementCAUTION: Frequent inhalation of brake pad dust, regardless of material composition, could be hazardous to your health.
^ Avoid breathing dust particles.
^ Never use an air hose or brush to clean brake assemblies. Use an OHSA-Approved vacuum cleaner.
NOTICE: To avoid damage, do not strike aluminum parts with a metal hammer. If necessary, tap gently with a plastic tipped hammer.
NOTE: Nuts and bolts with the [star] mark are special corrosion-resistant Dacro fasteners. Use the same type if replacement is necessary.
Inspection
1. Raise the front of the vehicle, and support it with safety stands in the proper location. Remove the front wheels.
2. Check the thickness of the inner pad (A) and outer pad (B). Do not include the thickness of the backing plate.
Brake pad thickness:
Standard: 8.0 - 9.0 mm (0.31 - 0.35 inch)
Service limit: 1.5 mm (0.06 inch)
3. If the brake pad thickness is less than the service limit, replace all the pads as a set.