Power Seat Motor Position Sensor: Service and Repair
Driver's Seat Position Sensor ReplacementRemoval
NOTE:
- Removal of the driver's seat position sensor must be performed according to the precautions/procedures described at the beginning of this section.
- Before disconnecting the driver's seat position sensor 2P connector, disconnect the driver's airbag 4P connector.
- Do not turn the ignition switch ON (II), and do not connect the battery cable while replacing the driver's seat position sensor
1. Disconnect the battery negative cable, and wait at least 3 minutes before beginning work.
2. Remove the driver's seat assembly.
3. Disconnect the driver's seat wire harness 2P connector (with power seat), or the driver's seat position sensor subharness 2P connector (without power seat) from the driver's seat position sensor (A).
4. Remove the Torx bolt (B) using a Torx T30 bit, then remove the driver's seat position sensor.
Installation
NOTE:
- Be sure to install the harness wires so they are not pinched or interfering with other parts.
- Do not turn the ignition switch ON (II), and do not connect the battery cable while replacing the driver's seat position sensor.
- After installing the driver's seat position sensor, make sure it is clean. Keep it away from dust.
1. Install the new driver's seat position sensor with a new Torx bolt (A) then connect the driver's seat wire harness 2P connector (with power seat), or the driver's seat position sensor subharness 2P connector (without power seat) to the driver's seat position sensor (B).
2. Install the driver's seat assembly.
3. Reconnect the battery negative cable.
4. After the driver's seat position sensor has been installed, check its operation with the Honda PGM Tester or HDS.