Programming and Relearning

Resetting the power window control unit

Resetting the power window control unit is required after performing the following procedures:
- Disconnecting the battery.
- Removing the No.79 (20 A) fuse in the under-hood subfuse box.
- Disconnecting the 18P connector from the power window control unit.
- Removing the window regulator, glass or glass run channel.
- Disconnecting the driver's door wire harness.

1. Turn the ignition switch off, then back ON (II).
2. Move the driver's window all the way down by using the driver's switch; when the window reaches the bottom, hold the driver's window switch in the DOWN position for 2 seconds.
3. Move the driver's window all the way up without stopping by using the driver's switch; when the window reaches the top, hold the driver's window switch in the UP position for 2 seconds.

If the window does not work in AUTO, reset the power window control unit according to the above procedures again.