Audio Unit
Audio Unit Removal/InstallationWith Navigation System:
SRS components are located in this area. Review the SRS component locations, and the precautions and procedures in the SRS section before performing repairs or service.
NOTE:
- Put on gloves to protect your hands.
- Take care not to scratch the dashboard and related parts.
1. Make sure you have the anti-theft codes for the radio and navigation system, then write down the frequencies for the radio's preset buttons.
2. Remove the center lower cover.
3. Remove the bolts (A).
4. Disconnect the all connectors and the antenna lead from the audio unit (B) and the climate control unit (C).
5. Remove the screws (A) and the audio unit (B).
6. Install the audio unit and the climate control unit in the reverse order of removal, and note these items:
- Make sure the audio unit and climate control unit connectors are plugged in properly, and the antenna lead is connected properly.
- After connecting the battery, do the PCM idle learn procedure.
- Do the power window resetting procedure.
- Enter the anti-theft codes for the radio and navigation system, then enter the customer's radio station presets and set the clock.
Without Navigation System:
SRS components are located in this area. Review the SRS component locations, and the precautions and procedures in the SRS section before performing repairs or service.
NOTE:
- Put on gloves to protect your hands.
- Take care not to scratch the dashboard and related parts.
1. Make sure you have the anti-theft codes for the radio, then write down the frequencies for the radio's preset buttons.
2. Remove the center panel.
3. Remove the bolts (A).
NOTE: The illustration shows the EX model.
4. Disconnect the audio unit connector (B), the optional accessory connector (if equipped), and the antenna lead (C) from the audio unit.
5. Remove the screws (A) from the audio unit.
NOTE: The illustration shows the EX model.
6. Install the audio unit in the reverse order of removal, and note these items:
- Make sure the audio unit connectors are plugged in properly, and the antenna lead is connected properly.
- After connecting the battery, do the PCM idle learn procedure.
- Do the power window resetting procedure.
- Enter the anti-theft codes for the radio, then enter the customer's radio station presets and set the clock.