Fluid Line/Hose: Service and Repair

ATF Cooler Hoses Installation





1. Side the ATF cooler hoses (A) over the ATF cooler lines (B), then secure the hoses with the clips (C) at 6 - 8 mm (0.2 - 0.3 inch) (D) from the hose ends.
2. Side the ATF cooler hoses (E) over the ATF cooler lines (F) at the ATF cooler, then secure the hoses with the clips (G) at 2 - 4 mm (0.1 - 0.2 inch) (H) from the hose ends.
3. Clamp the ATF cooler hose with the clamp (I) on the starter by aligning the white dot on the hose with the clamp.