Transfer Assembly Removal

Transfer Assembly Removal
1. Raise the vehicle, and make sure it is supported securely.





2. Remove the drain plug (A), and drain the automatic transmission fluid (ATF). Reinstall the drain plug with a new sealing washer (B).





3. Remove the primary heated oxygen sensor (Primary H02S) connector (A) from its connector bracket (B), then disconnect the connector.





4. Remove the front subframe stiffener.





5. Remove the Primary H02S harness clamp bracket (A) from the transmission.
6. Remove the harness from the harness clamp (B).





7. Remove the exhaust pipe (A).





8. Make a reference mark (A) across the propeller shaft (B) and the transfer companion flange (C).
9. Separate the propeller shaft from the transfer.





10. Remove the transfer assembly from the transmission.