Do you have access to Mitchell1 Prodemand? If you are willing to share user/password (we can pay), please get in contact with us ASAP (truly, it is urgent): email operation-charm [[at]] tuta.io or click to submit anonymously

DTC 32-10

DTC 32-10: Open or Increased Resistance in Front Passenger's Side Airbag Inflator

Special Tools Required
- SRS inflator simulator 07SAZ-TB4011A
- SRS simulator lead E 07XAZ-S1A0200

1. Erase the DTC memory.
2. Turn the ignition switch ON (II), and check that the SRS indicator comes on for about 6 seconds and then goes off.

Does the SRS indicator stay on, and is DTC 32-10 indicated?

YES - Go to step 3.

NO - Intermittent failure, system is OK at this time. Go to Troubleshooting Intermittent Failures. If another DTC is indicated, go to the DTC Troubleshooting Index.

3. Turn the ignition switch OFF. Disconnect the battery negative cable, and wait for 3 minutes.

4. Disconnect the right floor wire harness 2P connector (A) from the front passenger's side airbag (B).
5. Connect the SRS inflator simulator (2 Ohms connector) and simulator lead E to the right floor wire harness.
6. Reconnect the battery negative cable.
7. Erase the DTC memory.
8. Read the DTC.

Is DTC 32-10 indicated?

YES - Go to step 9.

NO - Open or increased resistance in the front passenger's side airbag inflator; replace the front passenger's side airbag.

9. Turn the ignition switch OFF. Disconnect the battery negative cable, and wait for 3 minutes.
10. Disconnect both seat belt tensioner 4P connectors.
11. Disconnect SRS unit connector B (28P) from the SRS unit.
12. Disconnect the SRS inflator simulator from the SRS simulator lead.

13. Check resistance between the terminals of the SRS simulator lead. There should be 1.0 Ohm or less.

Is the resistance as specified?

YES - Faulty SRS unit or poor contact at SRS unit connector B (28P) and the SRS unit. Check the connection; if the connection is OK, replace the SRS unit.

NO - Go to step 14.

14. Disconnect left floor wire harness 2P connector C683 (A) from the right floor wire harness connector C683(B).

15. Check resistance between the No. 1 and No. 2 terminals of left floor wire harness 2P connector C683. There should be 1.0 Ohm or less.

Is the resistance as specified?

YES - Open or increased resistance in the right floor wire harness; replace the right floor wire harness.

NO - Open or increased resistance in the left floor wire harness; replace the left floor wire harness.