Ignition Switch: Testing and Inspection
Ignition SwitchTest
SRS components are located in this area. Review the SRS component locations and the precautions and procedures before performing repairs or service.
1. Make sure you have the anti-theft code for the radio and the navigation system, then write down the customer's audio presets.
2. Connect the HDS to the date link connector (DLC), and ground the SCS.
3. Disconnect the battery negative cable.
4. Remove the left front door sill trim and left kick panel.
5. Disconnect the 6P connector from the under-dash fuse/relay box.
6. Check for continuity between the terminals in each switch position according to the table.
7. If the continuity checks do not agree with the table, replace the steering lock.
8. After reconnecting the battery, enter the anti-theft code for the radio and the navigation system, then enter the customer's audio presets.
9. If the IMA battery level gauge (BAT) displays no segments, start the engine, and hold it between 3,500 rpm and 4,000 rpm without load (in Park or neutral) until the BAT displays at least three segments.
10. Do the power window control unit reset procedure.