How to End A Troubleshooting Session

How to End a Troubleshooting Session
This procedure must be done after any troubleshooting.
1. Turn the ignition switch OFF.
2. Connect the HDS to the DLC.
3. Turn the ignition switch ON (II).
4. Clear the DTC(s) on the HDS screen.
5. Turn the ignition switch ON (II).
6. Enter the radio code, reset the preset stations, and set the clock.
7. Do the ECM idle learn procedure.
8. Calibrate the feedback signal for the start clutch pressure control system.
9. To verify that the problem is repaired, test-drive the vehicle for several minutes at speeds over 30 mph (50 km/h) or in freeze data range.