2-Door

Master Switch Test/Replacement

2-door

1. Remove the switch panel.




2. Remove the screws and the power window master switch (A) from the door panel.
3. Disconnect the 14P connector (B) from the switch.




4. Check for continuity between the terminals in each switch position according to the table.

Driver's Switch:

The driver's switch is combined with the control unit so you cannot isolate the switch to test it. Instead, run the master switch input test procedures, If the tests are normal, the driver's switch must be faulty.

5. If the switch is faulty, remove the three screws and replace the switch.