Harmonic Balancer - Crankshaft Pulley: Service and Repair

Crankshaft Pulley Removal and Installation

Special Tools Required
^ Holder handle 07JAB-001020A
^ Holder attachment, 50 mm, offset 07MAB-PY3010A Socket, 19 mm 07JAA-001020A or a commercially-available 19 mm socket

Removal





1. Hold the pulley with holder handle (A) and holder attachment (B).

2. Remove the bolt with a heavy duty 19 mm socket (C) and breaker bar.

Installation





1. Remove any oil from the pulleys (A), guide plate (B), crankshaft (C), bolt (D), and washer (E). Clean and lubricate as shown.





2. Install the crankshaft pulley, and tighten bolt to 200 Nm (148 lb.ft.).
Do not use an impact wrench.
Hold the pulley with holder handle (A) and holder attachment (B).
Tighten the bolt with a torque wrench and 19 mm socket (C).