DTC 23

DTC 23: Magnetic Encoder
1. Clear the DTC using the HDS.
2. Disconnect the HDS from the 16P DLC.
3. Test-drive the vehicle at 19 mph (30 km/h) or more.
Does the ABS indicator come on, and are DTCs 21, 22, 23, and/or 24 indicated?
YES - Go to step 4.
NO - The system is OK at this time.





4. Check the appropriate wheel sensor (see table).
Is the encoder OK?
YES - Go to step 5.
NO - Replace the wheel sensor.
5. Check that the encoders are installed correctly, and free from debris:
^ Front encoder
^ Rear encoder
Are they clean and installed correctly?
YES - Check for loose terminals in the ABS control unit 47P connector. If necessary, substitute a known-good ABS modulator-control unit, and recheck.
NO - Clean and reinstall or replace the appropriate encoder.