Oil Pan Installation

Installation
1. Remove old liquid gasket from the oil pan mating surfaces, bolts, and bolt holes.
2. Clean and dry the oil pan mating surfaces.





3. Apply liquid gasket, P/N 08718-0009, evenly to the cylinder block mating surface of the oil pan and to the inner threads of the bolt holes.

NOTE: Do not install the parts if4 minutes or more have elapsed since applying liquid gasket. Instead, reapply liquid gasket after removing old residue.

4. Install the oil pan.





5. Tighten the bolts in two or three steps. In the final step, tighten all bolts, in sequence, to 12 Nm (1.2 kgf-m, 8.7 ft. lbs.).





6. Install the stiffener (M/T).
7. If the engine is still in the vehicle, install the subframe.
1. support the subframe with the special tool and a jack, and lift it up to body, then loosely install the new subframe mounting bolts.
2. Align the reference marks with the center of the subframe mounting bolts, then tighten the bolts to the specified torque.
3. Install the Automatic Transmission Fluid (ATF) filter mounting bolt.
4 Tighten the rear mount mounting bolts.
5. Tighten the front mount mounting bolt.
6. Connect the suspension lower arm ball joints.
8. After assembly, wait at least 30 minutes before filling the engine with oil.