Crankshaft Pulley Removal and Installation

Removal and Installation

Special Tools Required
- Holder handle 07JAB-001020A
- Holder attachment, 50 mm 07NAB-001040A
- Socket, 19 mm 07JAA-001020A or a commercially available 19 mm socket

Removal
1. Remove the front tires/wheels.
2. Remove the splash shield.





3. Hold the pulley with holder handle (A) and holder attachment (B).
4. Remove the bolt with a 19 mm socket (C) and breaker bar.

Installation





1. Clean the crankshaft pulley (A), crankshaft (B), bolt (C), and washer (D). Lubricate as shown.





2. Install the crankshaft pulley, and hold the pulley with holder handle (A) and holder attachment (B).
3. Tighten the bolt to 49 Nm (5.0 kgf-m, 36 lb-ft) with a torque wrench and 19 mm socket (C). Do not use an impact wrench.
4. Tighten the pulley bolt on additional 90°.
5. Install the drive belt
6. Install the splash shield.
7. Install the front tires/wheels.