Operation CHARM: Car repair manuals for everyone.
Home >> Honda >> 2005 >> Element 4WD L4-2.4L >> Repair and Diagnosis >> Powertrain Management >> Transmission Control Systems >> Testing and Inspection >> Component Tests and General Diagnostics >> Component Tests >> Shift Solenoid Valve Test

Shift Solenoid Valve Test

Shift Solenoid Valve Test





1. Connect the HDS to the DLC (A).
2. Select Shift Solenoid A, B, C, and E in Miscellaneous Test Menu on the HDS.
3. Check that the shift solenoid valve A, B, C, and E operate with the HDS. A clicking sound should be heard.
4. Shift solenoid valves test has finished if the test results are OK. If no sound is heard, remove the shift solenoid valves and test.





5. Remove the drain plug (A), and drain the automatic transmission fluid (ATF).
6. Reinstall the drain plug with a new sealing washer (B).
7. Place the transmission jack under the transmission, and lift it up to create clearance between the transmission and front subframe.
8. Disconnect the shift solenoid harness connector.





9. Remove the bolt (A) securing the bracket (B) of the ATF cooler inlet line (C) on the shift solenoid valve cover (D), and remove the line bolt (E) with sealing washers (F).
10. Remove the shift solenoid valve cover (D), gasket (G), and dowel pins (H).





11. Remove the bolt (A), and remove the shift solenoid harness connector (B).
12. Measure shift solenoid valves resistance between the shift solenoid harness connector terminals No. 1, No. 2, No. 3, No. 5 and body ground.
^ Shift solenoid valve A: No. 5 terminal (BLU)
^ Shift solenoid valve B: No. 2 terminal (ORN)
^ Shift solenoid valve C: No. 1 terminal (GRN)
^ Shift solenoid valve E: No. 3 terminal (RED)
Standard: 12 - 25 Ohms
13. If the resistance is out of standard, disconnect the shift solenoid valve connector, and measure its resistance at the solenoid valve terminal. Replace the shift solenoid valve if the resistance is out of standard.
14. Connect the battery negative terminal to body ground, and connect the battery positive terminal to the shift solenoid harness connector terminals individually. A clicking sound should be heard.
15. If no sound is heard, connect the battery positive terminal to the shift solenoid valve terminal, and check that the clicking sound is heard. Replace the shift solenoid valve if no sound is heard.
16. Replace the solenoid harness if the tests results are OK.
17. Install the new O-ring on the shift solenoid harness connector, and install the connector in the transmission housing.
18. Install the shift solenoid valve cover with the new gasket and dowel pins.
19. Install the ATF cooler inlet line with the line bolt and the new sealing washers. Create clearance with the jack between the transmission and the front subframe to tighten the line bolt with the torque wrench.
20. Install the bracket of the ATF cooler inlet line on the shift solenoid valve cover with the bolt.
21. Check the connector for rust, dirt, or oil, then connect the connector securely.
22. Remove the transmission jack.
23. Refill the transmission with the recommended fluid.

pro multis · About Operation CHARM