Transmission Installation

Transmission Installation

Special Tools Required
^ Engine hanger/adapter VSB02C000015*
^ Engine support hanger, A & Reds AAR-T-12566*
^ Subframe adapter EQS02C000011 *
^ Available through the Honda Tool and Equipment Program at 888-424-6857.

1. Check that the two dowel pins are installed in the clutch housing.





2. Apply super high temp urea grease (P/N 08798-9002) to the release fork (A) and the release bearing (B). Install the release fork, the release bearing, and the boot (C).





3. Install the transmission rear mount bracket (A) and the transmission rear mount (B).
4. Place the transmission on the transmission jack, and raise it to the engine level.





5. Install the two transmission lower mounting bolts.





6. Install the front engine mount.





7. Install the clutch cover.





8. Support the subframe with the subframe adapter and a jack.





9. Install the front suspension subframe (A) in its original position by aligning the marks (B) you made in the removal procedure.





10. Install the three bolts for the transmission rear mount.





11. Loosely install the front engine mount bracket bolt
12. Install the intermediate shaft.
13. Install the front driveshafts.





14. Install the transmission mount bracket (A) and the transmission mounting bolt (B).
15. Install the air cleaner bracket (C).





16. Loosen the front engine mount bracket mounting bolt, then tighten the front engine mount bracket mounting bolt.





17. Install the splash shield.





18. Install the two transmission upper mounting bolts.
19. Remove the engine hanger and special tool from the engine.





20. Apply super high temp urea grease (P/N 08798-9002) to the end of the cylinder rod. Install the slave cylinder. Be careful not to bend the clutch line.





21. Install the cable bracket (A) and cables (B).
22. Apply a light coat of super high temp urea grease (P/N 08798-9002) to the cable ends, and install new cotter pins (C).





23. Connect the mainshaft speed sensor connector (A) and back-up light switch connector (B).
24. Install the ground cable (C).





25. Install the battery tray.
26. Install the intake air duct.
27. Install the air cleaner housing.
28. Install the battery. Connect the positive (+) cable first, then the negative (-) cable.
29. Refill the transmission fluid.
30. Do the idle learn procedure.
31. Test-drive the vehicle.
32. Check the clutch operation.
33. Check the front wheel alignment.
34. Enter the anti-theft code for the radio, then enter the customer's radio station presets, and set the clock.
35. Do the power window control unit reset procedure.