P0523
DTC P0523: EOP Sensor Circuit High Voltage1. Turn the ignition switch ON (II).
2. Check the OIL PRESSURE SENSOR in the DATA LIST with the HDS.
Is there about 4.79 V or more?
YES - Go to step 3.
NO - Intermittent failure, system is OK at this time. Check for poor connections or loose terminals at the oil pressure sensor and the PCM.
3. Turn the ignition switch OFF.
4. Disconnect the EOP sensor 3P connector.
5. Connect EOP sensor 3P connector terminals No.2 and No.3 with a jumper wire.
6. Turn the ignition switch ON (II).
7. Check the OIL PRESSURE SENSOR in the DATA LIST with the HDS.
Is there about 4.79 V or more?
YES - Go to step 8.
NO - Go to step 18.
8. Remove the jumper wire.
9. Measure voltage between EOP sensor 3P connector terminals No.1 and No.3.
Is there about 5 V?
YES - Go to step 14.
NO - Go to step 10.
10. Turn the ignition switch OFF.
11. Jump the SCS line with the HDS.
12. Disconnect PCM connector C (44P).
13. Check for continuity between PCM connector terminal C14 and EOP sensor 3P connector No.3.
Is there continuity?
YES - Go to step 26.
NO - Repair open in the wire between the PCM (C14) and EOP sensor, then go to step 20.
14. Turn the ignition switch OFF.
15. Jump the SCS line with the HDS,
16. Disconnect PCM connector C (44P).
17. Check for continuity between PCM connector terminal C22 and EOP sensor 3P connector No.2.
Is there continuity?
YES - Go to step 26.
NO - Repair open in the wire between the PCM (C22) and EOP sensor, then go to step 20.
18. Turn the ignition switch OFF.
19. Replace the EOP sensor.
20. Reconnect all connectors.
21. Turn the ignition switch ON (II).
22. Reset the PCM with the HDS.
23. Do the PCM idle learn procedure.
24. Check for Temporary DTCs or DTCs with the HDS.
Are any Temporary DTCs or DTCs indicated?
YES - If DTC P0523 is indicated, check for poor connections or loose terminals at the EOP sensor and the PCM, then go to step 1. If any other Temporary DTCs or DTCs are indicated, go to the indicated DTC's troubleshooting.
NO - Go to step 25.
25. Monitor the OBD STATUS for DTC P0523 in the DTCs MENU with the HDS.
Does the screen indicated PASSED?
YES - Troubleshooting is complete.
NO - If the screen indicates FAILED, check for poor connections or loose terminals at the EOP sensor and the PCM, then go to step 1. If the screen indicates NOT COMPLETED, go to step 23 and recheck.
26. Update the PCM if it does not have the latest software, or substitute a known-good PCM.
27. Check for Temporary DTCs or DTCs with the HDS.
Are any Temporary DTCs or DTCs indicated?
YES - If DTC P0523 is indicated, check for poor connections or loose terminals at the EOP sensor and the PCM, then go to step 1. If any other Temporary DTCs or DTCs are indicated, go to the indicated DTC's troubleshooting.
NO - If the PCM was updated, troubleshooting is complete. If the PCM was substituted, replace the original PCM.