Cowl Moulding / Trim: Service and Repair

Cowl Cover Replacement

Special Tools Required
KTC trim tool set SOJATP2014

NOTE:
- Take care not to scratch the cowl cover and body.
- Use the appropriate tool from the KTC trim tool set to avoid damage when prying components.

1. Remove the windshield wiper arms.




2. Using a trim tool, remove the clips (A) from the cowl cover (B), and detach the clips (C, D) by carefully pulling the windshield side edge of the cover upward.
3. If necessary, using a trim tool, detach the clips (E), then remove the hood rear seal (F).




4. Release the hooks (A) of the cowl cover (B) by pulling the cover forward. From both hood hinge portions, release the hooks (C, D) of the hood hinge cover (E) from the front fender (F) and the windshield side trim (G).
5. Release the windshield washer tube (H) from the cover, then remove the cover.
6. Install the cover in the reverse order of removal, and note these items:
- Check the clips for damage or stress-whitening, and replace them with new one.
- Push the clips into place securely.