Power Sliding Door Motor Sensor: Testing and Inspection
Sliding Door Touch Sensor Test/Replacement1. Remove the sliding door panel.
2. Disconnect the 2P connector (A) from the touch sensor(B).
3. Measure resistance between the touch sensor 2P connector No. 1 and No. 2 terminals. The resistance should vary from about 1 kOhms,to about 120 Ohms, when the sensor is pressed.
4. If the resistance is not as specified, remove the screws, then replace the touch sensor.
5. Install in the reverse order of removal. After installing, make sure the sliding door operates properly.