A/T Clutch Pressure Control Solenoid Valve C Test

A/T Clutch Pressure Control Solenoid Valve C Test





1. Connect the HDS to the DLC (A).
2. Choose Clutch Pressure Control (Linear) Solenoid C in Miscellaneous Test Menu on the HDS.
3. Test the A/T clutch pressure control solenoid valve C with the HDS.
^ If the valve tests OK, the test is complete. Disconnect the HDS.
^ If the valve does not test OK, follow the instructions on the HDS.
^ If the valve does not test OK, and the HDS does not determine the cause, go to step 4.
4. Get the customer's radio anti-theft code (navigation code), and write down the radio station presets.
5. Disconnect the battery negative terminal, then disconnect the battery positive terminal.
6. Remove the battery hold-down bracket, then remove the battery cover, battery, and battery tray.
7. Remove the intake air duct and air cleaner housing.
8. Loosen the two bolts securing the rear of the battery base, and remove the two bolts securing the front of the base, then remove the battery base.





9. Disconnect A/T clutch pressure control solenoid valve C connector.
10. Measure A/T clutch pressure control solenoid valve C resistance at the solenoid valve connector.
Standard: 3 - 10 Ohms
^ If the resistance of the solenoid valve is out of standard, replace A/T clutch pressure control solenoid valve C.
^ If the resistance is within the standard, go to step 11.
11. Connect the battery negative terminal to A/T clutch pressure control solenoid valve C connector terminal No. 2, and connect the battery positive terminal to the terminal No. 1.
^ If a clicking sound is heard, the valve is OK. Reconnect the connector, and install all removed parts.
^ If no clicking sound is heard, go to step 12.





12. Remove A/T clutch pressure control solenoid valve C.
13. Remove the gasket (A) and 8 x 12 mm ATF feed pipe (B).





14. Connect the battery negative terminal to A/T clutch pressure control solenoid valve C connector terminal No. 2, and connect the battery positive terminal to the terminal No. 1. Make sure A/T clutch pressure control solenoid valve C moves.
15. Disconnect one of the battery terminals and check valve movement at the fluid passage in valve body mounting surface. If the valve binds or moves sluggishly, or if the solenoid valve does not operate, replace A/T clutch pressure control solenoid valve C.
16. Check the fluid passage of the A/T clutch pressure control solenoid valve for dust and dirt, and clean the passage if necessary.
17. Install the 8 x 12 mm ATF feed pipe with its filter side into the transmission housing.
18. Install the new gasket in the mounting groove of the A/T clutch pressure control solenoid valve C body, then install A/T clutch pressure control solenoid valve C on the transmission housing. Do not pinch the gasket.
19. Check the A/T clutch pressure control solenoid valve C connector for rust, dirt, or oil, then connect it securely.
20. Install the battery base, then install the air cleaner housing and intake air duct.
21. Install the battery tray, battery, and battery cover, then secure the battery with its hold-down bracket.
22. Enter the radio code (navigation code), reset the radio presets and set the clock.
23. Do the power window control unit reset procedure.