Cylinder Head Cover Installation
Cylinder Head Cover Installation1. Clean the head cover contacting surfaces with a shop towel.
2. Visually check the spark plug seals for damage. Replace if necessary.
3. Set the spark plug seals (A) on the spark plug tubes, and install the cylinder head cover (B).
4. Inspect the cover washer (C). Replace any washer that is damaged or deteriorated.
5. Tighten the bolts in two or three steps. In the final step tighten all bolts, in sequence, 12 Nm (1.2 kgf-m, 8.7 ft. lbs.).
6. Tighten the harness holder mounting bolts (A) and the power steering hose bracket mounting bolt (B).
7. Install the harness clamps (C) and breather hose (D).
8. Connect the three injector connectors to the injectors on the cylinder head.
9. Tighten the three bolts (A) securing the harness holder and bracket, then install the harness clamp (B) and dipstick (C).
10. Install the six ignition coils.
11. Install the intake manifold.