SRS Indicator Stays ON:

SRS indicator stays on, but no DTCs are stored

1. Check for DTCs using Manual Mode. If there are no DTCs, continue troubleshooting.
2. Disconnect the battery negative cable, and wait for 3 minutes.
3. Disconnect SRS unit connector A (28P) from the SRS unit.




4. Remove the gauge assembly. Disconnect gauge assembly connector B (22P) from the gauge assembly.




5. Check resistance between No. 7 terminal of gauge assembly connector B (22P) and the No. 19 terminal of SRS unit connector A (28P). There should be 1 Ohm, or less.

Is the resistance as specified?

YES - Faulty SRS indicator circuit in the gauge assembly or poor contact at gauge assembly connector B; check the connection. If the connection is OK, replace the gauge assembly.

NO - Open in dashboard wire harness A; replace the dashboard wire harness A.