Clutch Pressure Control Solenoid Valve A and B Replacement

A/T Clutch Pressure Control Solenoid Valve A and B Replacement
1. Remove the bolt securing the harness cover.
2. Remove the two bolts securing the connector bracket.
3. Remove the bolt securing the ATF cooler lines to the transmission end cover.
4. Place shop rags around the ATF cooler line bolts to remove the ATF that flows out,
5. Remove the ATF cooler line bolts from the transmission housing.
6. Remove the harness clamp from the harness clamp bracket (G), and disconnect the connectors from A/T clutch pressure control solenoid valves A and B.





7. Remove the mounting bolts and A/T clutch pressure control solenoid valves A and B.
8. Clean the mounting surface and fluid passages of A/T clutch pressure control solenoid valves A and 8 and the transmission housing.
9. Place a new gasket (C) on the transmission housing, then install the 8 x 18 mm ATF feed pipes (D) with their filter side into the transmission housing.
10. Install new O-rings (E) over the feed pipes, and install the 8 x 40 mm ATF feed pipe (F),
11. Install the new A/T clutch pressure control solenoid valves A and 8, and harness clamp bracket (G).
12. Check the A/T clutch pressure control solenoid valves A and B connectors for rust, dirt, or oil, then connect them securely.
13. Install the ATF cooler lines with new sealing washers.
14. Secure the ATF cooler lines to the transmission end cover with the bolt.
15. Install the connector bracket and harness cover.