Clutch Pressure Control Solenoid Valve C Test

A/T Clutch Pressure Control Solenoid Valve C Test





1. Connect the HDS to the DLC (A).
2. Choose Clutch Pressure Control (Linear) Solenoid C in Miscellaneous Test Menu on the HDS.
3. Test the A/T clutch pressure control solenoid C with the HDS.
4. A/T clutch pressure control solenoid valve C test has finished if the test result is OK. If the HDS identifies a possible fault in the system, go to step 5.





5. Disconnect A/T clutch pressure control solenoid valve C connector.
6. Measure A/T clutch pressure control solenoid valve C resistance at the solenoid valve connector.
Standard: 3 - 10 Ohms
7. If the resistance of the solenoid valve is out of standard, replace A/T clutch pressure control solenoid valve C.
8. If the resistance is within the standard, go to step 9.
9. Remove the A/T clutch pressure control solenoid valve C.





10. Connect the battery negative terminal to A/T clutch pressure control solenoid valve C connector terminal No. 2, and connect the battery positive terminal to the terminal No. 1. Make sure A/T clutch pressure control solenoid valve C moves.
11. Disconnect one of the battery terminals and check valve movement at the fluid passage in valve body mounting surface.
12. If the valve binds or moves sluggishly, or if the solenoid valve does not operate, replace A/T clutch pressure control solenoid valve C.
13. Check the fluid passage of the A/T clutch pressure control solenoid valve for dust and dirt, and clean the passage if necessary.
14. Check the A/T clutch pressure control solenoid valve C connector for rust, dirt, or oil. Clean as necessary, then reconnect the connector.