Map Light: Service and Repair
Front Individual Map Light Test/ReplacementWith navigation
1. Turn the map light switch OFF.
2. Carefully pry the lens (A) off with a small screwdriver.
3. Remove the screws, then remove the map lights (B) and navigation microphone (C).
4. Disconnect the 3P connector from the map lights and the 10P connector from the navigation microphone.
5. Check for continuity between the terminals in each switch position according to the table.
6. If the continuity is not as specified, check the bulb(s). If the bulb(s) are OK, replace the light.
7. Install in the reverse order of removal.
Without navigation
1. Turn the map light switch OFF.
2. Carefully pry the lens (A) off with a small screw driver.
3. Remove the screws, then remove the map lights (B).
4. Disconnect the 3P connector (C) from the map lights.
5. Check for continuity between the terminals in each switch position according to the table.
6. If the continuity is not as specified, check the bulb(s). If the bulb(s) are OK, replace the light.
7. Install in the reverse order of removal.