ATF Cooler Replacement
ATF Cooler Replacement1. Remove the front bulkhead cover.
2. Remove the front bumper.
3. Disconnect the ATF cooler hoses (A) from the ATF cooler lines.
4. Remove the splash shield (B), and remove the ATF cooler and cooler hoses assembly (C).
5. Install the new ATF cooler and cooler hoses assembly.
6. Slide the cooler hoses (A) over the ATF cooler lines (B) until the hose ends (C) contact with the bulge (D), and secure the hoses with the clips (E) at 6 - 8 mm (0.2 - 0.3 inch) (F) from the hose end.
7. Make sure that the hose clamp (G) is installed at the mark (H).
8. Install the splash shield on the bulkhead bracket.
9. Install the bumper.
10. Install the bulkhead cover.