Rear Bumper: Service and Repair
Rear Bumper Removal/InstallationNOTE:
- Have an assistant help you remove and install the rear bumper.
- Take care not to scratch the rear bumper and body.
- Put on gloves to protect your hands.
1. Remove the rear bumper as shown. For '04-07 models, to release the speed nuts, refer to front grille replacement.
2. Install the bumper in the reverse order of removal, and note these items:
- Make sure the rear bumper engages the hooks (bumper spacers and under the taillight) on each side securely.
- Make sure the license plate light connector is plugged in properly.
- Check for damaged or stress-whitened clips, and replace them with new ones.
- Replace the speed nuts with new ones ('04-07 models).
- For'04-07 models: If the rear bumper protector is reinstalled, clean it and the bumper with a sponge dampened in alcohol. Apply primer to the protector surface, and then apply new double-sided tape.
- Push the clips into place securely.