Starter Solenoid: Testing and Inspection
Starter Solenoid Test1. Make sure you have anti-theft code for the radio, then write down the audio presets.
2. Disconnect the negative cable from the battery first, then disconnect the positive cable.
3. Disconnect the starter cable (A), BLK/WHT wire (B), and motor cable (C).
4. Check the hold-in coil for continuity between the S terminal and the armature housing (ground). There should be continuity.
- If there is continuity, go to step 2.
- If there is no continuity, replace the solenoid.
5. Check the pull-in coil for continuity between the S terminal and the M terminal. There should be continuity.
- If there is continuity, the solenoid is OK.
- If there is no continuity, replace the solenoid.
6. Connect the starter cable, BLK/WHT wire, and motor cable.
7. Connect the positive cable to the battery first, then connect the negative cable.
8. 2000-2005 models: Do the ECM idle learn procedure.
9. Enter the anti-theft code for the radio, then enter the audio presets.
10. Set the clock.