4th Clutch Transmission Fluid Pressure Switch Replacement
4th Clutch Transmission Fluid Pressure Switch Replacement1. Get the audio and navigation anti-theft codes, and write down the audio presets.
2. Disconnect the negative cable from the battery, then disconnect the positive cable from the battery.
3. Remove the battery hold-down bracket, then remove the battery cover, battery, and battery tray.
4. Loosen the two bolts securing the battery base from under the vehicle, and remove the two bolts securing the battery base in the engine compartment, then remove the battery base.
5. Disconnect the connector from the 4th clutch transmission fluid pressure switch (A).
6. Replace the switch, then install a new one with a new sealing washer (B). Tighten the switch on the metal part, not the plastic part.
7. Check the connector for water, oil, dust, or other particles inside it, and connect the connector securely.
8. Install the battery base and battery, then connect the battery terminals.
9. Clean the battery posts and cable terminals with sandpaper, then assemble them and apply grease to prevent corrosion.
10. Enter the audio and navigation anti-theft codes, then enter the presets, and set the clock.
11. Do the power window control unit reset procedure.