Operation CHARM: Car repair manuals for everyone.
Home >> Honda >> 2007 >> Element 2WD L4-2.4L >> Repair and Diagnosis >> Powertrain Management >> Fuel Delivery and Air Induction >> Fuel Tank Unit >> Service and Repair >> Fuel Tank Unit Removal/Installation
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Fuel Tank Unit Removal/Installation

Fuel Tank Unit Removal/Installation

Special Tools Required
Fuel sender wrench 07AAA-S0XA100

Removal

1. Relieve the fuel pressure.
2. Remove the fuel fill cap.
3. Remove the center console.




4. Fold back the floor mat until the access panel is accessible. Remove the access panel (A) from the floor.
5. Disconnect the fuel tank unit 4P connector (B).
6. Disconnect the quick-connect fitting (C) from the fuel tank unit.




7. Using the special tool, loosen the locknut (A).




8. Remove the locknut (A) and the fuel tank unit (B).

Installation




1. Install a new base gasket (A) on the fuel tank (B).
2. Insert the fuel tank unit (C) into the fuel tank. Be careful not to bend the fuel gauge sending unit.
3. Align the marks (D) on the fuel tank and the fuel tank unit, then tighten a new locknut (E) by hand.

NOTE:
- After tightening, make sure the marks are aligned. Check circumference of the base gasket visually or by hand and be sure that the gasket is not pinched.
- Do not coat the base gasket with oil.




4. Using the special tool, tighten the fuel tank unit locknut (A).

NOTE: After installation, check the base gasket visually or by hand to be sure the gasket is not pinched.
pro multis · About Operation CHARM