Removal and Replacement
Starter Removal and InstallationRemoval
1. Make sure you have the anti-theft codes for the audio system and navigation system (if equipped), then write down the audio presets. Make sure the ignition switch is OFF.
2. Disconnect the negative cable from the battery first, then disconnect the positive cable.
3. Remove the battery and the battery base.
4. Remove the harness clamp (A).
5. Disconnect the starter cable (B) from the B terminal, then disconnect the connector (C) from the S terminal.
6. Remove the two bolts holding the starter, then remove the starter.
Installation
1. Install the starter (A) using a new gasket (B), then install the harness clamp (C), and connect the starter cable (D) to the B terminal and the connector (E) to the S terminal. Make sure the crimped side of the starter cable ring terminal is facing out, away from the starter.
2. Install the battery base and the battery.
3. Connect the positive cable to the battery first, then connect the negative cable.
4. Start the engine to make sure the starter works properly.
5. Enter the anti-theft codes for the audio system and navigation system (if equipped), then enter the audio presets.
6. Set the clock.