Trunk Pass-Through Lid Lock Cylinder Replacement

Trunk Pass-through Lid Lock Cylinder Replacement

Special Tools Required
KTC trim tool set SOJATP2014 *
* Available through the American Honda Tool and Equipment Program

4-door

NOTE:
- Take care not to scratch the trunk pass-through lid.
- Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.

1. Using the appropriate trim tool, pry the handle (A) up at both hook portions (B) on the forward side of the trunk pass-through lid (C). Then slide the handle half-way up.






2. Remove the handle (A) from the trunk pass-through lid (B) by sliding it up.






3. Remove the retainer clip (A), then remove the trunk pass-through lid lock cylinder (B) from the handle (C).






4. Install the lock cylinder in the reverse order of removal, and note these items:
- Install the retainer clip on the handle, then install the lock cylinder. Be sure the clip is fully seated in the slot on the lock cylinder.
- Make sure the trunk pass-through lid opens properly and locks securely.