Operation CHARM: Car repair manuals for everyone.
Home >> Honda >> 2008 >> Civic Si L4-2.0L >> Repair and Diagnosis >> Restraints and Safety Systems >> Air Bag Systems >> Impact Sensor >> Service and Repair >> Side Impact Sensor (First) Replacement
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Side Impact Sensor (First) Replacement

Side Impact Sensor (First) Replacement

NOTE: Review the seat replacement procedure before doing repairs or service.

Removal

1. Disconnect the negative cable from the battery, then wait for 3 minutes before starting work.
2. Disconnect the appropriate side airbag 2P connector.
3. Remove the front seat assembly.
4. Remove the front door sill inner trim.
5. Remove the lower B-pillar lower trim panel.
6. Disconnect the floor wire harness 4P connector from the side impact sensor (first).
7. Using a TORX T30 bit, remove the TORX bolt (A), then remove the side impact sensor (first) (B).






Installation

1. Install the side impact sensor (first) with a new TORX bolt (A), then connect the floor wire harness 4P connector (B) to the side impact sensor (first).






2. Reconnect the negative cable to the battery.
3. Reinstall all removed parts.
4. After installing the side impact sensor (first) confirm proper system operation: Turn the ignition switch ON (II); the SRS indicator should come on for about 6 seconds and then go off.
pro multis · About Operation CHARM