General Specifications
Cylinder headMeasure the diameter of each cylinder head bolt at point A and point B.
If either diameter is less than 8.6 mm (0.34 in.), replace the cylinder head bolt.
Tighten the cylinder head bolts in sequence 29 Nm (3.0 kgf-m, 22 lbf-ft)
Tighten all cylinder head bolts an additional 130°.
Intake manifold
Install the intake manifold (B) and tighten the bolts and nuts in a crisscross pattern in three steps, beginning with the inner bolt.
Camshaft sprocket
Exhaust manifold
10 x 1.25 mm 44 Nm (4.5 kgf-m, 33 lbf-ft) Replace