Transmission Position Sensor/Switch: Testing and Inspection

Transmission Range Switch Test
1. Make sure you have the anti-theft code for the audio system and the navigation system (if equipped).
2. Disconnect the negative cable from the battery, then disconnect the positive cable.
3. Remove the battery hold-down bracket, the battery and the battery tray.
4. Remove the engine cover and the air cleaner assembly.
5. Remove the battery base.
6. Disconnect the transmission range switch connector.





7. Check for continuity between terminals at the switch connector. There should be continuity between the terminals in the following table for each switch position.





8. Transmission range switch test is finished if the test results are OK. If there is no continuity between any terminals, check the transmission range switch installation. If the switch installation is OK, replace the switch.