Ignition Switch: Service and Repair
ReplacementSRS components are located in the area. Review the SRS component locations, and precautions and procedures before performing repairs or servicing.
1. Make sure you have the anti-theft codes for the audio system and the navigation system (if equipped). Make sure the ignition switch is OFF.
2. Disconnect the battery negative cable.
3. Remove the left front door sill trim and left kick panel.
4. Disconnect the 6P connector (A) from the under-dash fuse/relay box.
5. Remove the two screws and the ignition switch (B).
6. Install the reverse order of removal.
7. After reconnecting the battery, enter the anti-theft codes for the audio system and the navigation system (if equipped). Set the clock (on vehicles without navigation).
8. Confirm that all system work properly.
9. Do the power window control unit reset procedure.