Removal and Replacement
Starter Removal and InstallationRemoval
1. Make sure you have anti-theft codes for the audio system and navigation system (if equipped).
2. Disconnect the negative cable from the battery.
3. Remove the automatic transmission fluid (ATF) dipstick.
4. Remove the harness clamp (A).
5. Disconnect the starter cable (B) from the B terminal, then disconnect the BLK/WHT wire (C) from the S terminal.
6. Remove the two bolts holding the starter.
Installation
1. Install the starter (A) using a new gasket (C), then install the harness clamp (D), and connect the B terminal and BLK/WHT wire (E). Make sure the crimped side of the B terminal faces away from the starter when you connect it.
2. Install the automatic transmission fluid (ATF) dipstick.
3. Connect the negative cable.
4. Start the engine to make sure the starter works properly.
5. Enter the anti-theft codes for the audio system and navigation system (if equipped).
6. Do the power window control unit reset procedure.
7. Enter the anti-theft codes for the audio system and the navigation system (if equipped). Set the clock (on vehicles without navigation).