Center Console Removal/Installation

Center Console Removal/Installation

Special Tools Required

- KTC trim tool set SOJATP2014*
SRS components are located in this area. Review the SRS component locations Locations and the precautions and procedures Technician Safety Information before doing repairs or service.

NOTE:

- Put on gloves to protect your hands.

- Use the appropriate tool from the KTC trim tool set to avoid damage when prying components.

- Take care not to scratch the front seat, the dashboard, and related parts.

1. Slide the seat fully to the rear to access the front console trim.

2. From the front portion of the center console, detach the clips (A) by pulling out the front console trim (B) with a trim tool.

3. Detach the clips (C), then remove the front console trim. From the front portion of the center console, remove the bolts (D) and disconnect the subharness connector (E), and detach the harness clip.






4. Open the shutter (A), then remove the console box mat (B) and the bolts. Lift up the center console (C) and remove it.

5. Install the center console in the reverse order of removal, and note these items:
- Make sure the connector is plugged in properly.

- Push the clips and the hooks into place securely.

- If the clips are damaged or stress-whitened, replace them with new ones.