Rear Seat Armrest Cover Replacement

Rear Seat Armrest Cover Replacement

Special Tools Required

- KTC trim tool set SOJATP2014*
NOTE:

- Use the appropriate tool from the KTC trim tool set to avoid damage when prying components.

- Take care not to tear the seams or damage the seat covers.

1. Remove the armrest. Rear Seat Armrest Removal/Installation

2. Remove the beverage holder (A).
-1 Using a trim tool, push on the bottom ribs (B) of the left side hooks (C) to pull up the holder, then release the hooks from the wire (D).
Release the right side hooks (E) from the wire, then remove the holder.






3. Release the hook strip (A), and pull back the edge of the armrest cover (B) all the way around, and remove it.

4. Install the cover in the reverse order of removal, and note these items:
- To prevent wrinkles, make sure the material is stretched evenly over the armrest before securing the hook strip.

- Make sure the right side hooks of the beverage holder are installed securely on the wire, then push down on the holder, and install the left side hooks on the wire securely.