B2000

DTC Troubleshooting: B2000

DTC B2000:

Communication Bus Line Error (BUS OFF)

NOTE: If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN System Diagnosis Test Mode A Troubleshooting - B-CAN System Diagnosis Test Mode A.

1. Clear the DTCs with the HDS.

2. Turn the ignition switch to LOCK (0), and then back to ON (II).

3. Wait for at least 6 seconds.

4. Check for DTCs with the HDS.

Is DTC B2000 indicated?

YES -

Go to step 5.

NO -

Intermittent failure, the system is OK at this time. Check for loose or poor connections at left power sliding door control unit connector A (22P), at MICU-rear junction box connectors A (14P) and G (8P), and at driver's under-dash fuse/relay box connector G (6P).�

5. Check for DTCs with the HDS.

Is DTC B1000 also indicated?

YES -

Troubleshoot DTC B1000 B1000.�

NO -

If only B2000 is indicated, replace the left power sliding door control unit.�