Power Mirror Actuator Replacement (With DPMS)

Power Mirror Actuator Replacement

'08-10 Touring models

Removal

1. Remove the mirror holder Mirror Holder Replacement, the power mirror Power Mirror Replacement (Without DPMS), and disconnect the 13P connector.

2. Record the wire colors and the terminal locations of the mirror 13P connector.






3. Disassemble the power mirror 13P connector (A), and remove the terminals from it.






4. Remove the gasket (A), then remove the screw and clip (B).






5. Remove the three screws, and separate the mirror housing (A) from the bracket (B).






6. Remove the four screws and the actuator (A).






Installation

7. Route a new actuator harness through the bracket, and install the actuator in the reverse order of removal.

8. Insert the mirror actuator wires into the original terminal locations as noted in step 2.

9. Reassemble in the reverse order of disassembly. Be careful not to break the mirror holder when reinstalling it to the actuator Mirror Holder Replacement.

10. Reinstall the mirror assembly to the door.

11. Operate the power mirror to ensure smooth operation.