Third Row Seat Pivot Disassembly/Reassembly

Third Row Seat Pivot Disassembly/Reassembly

Special Tools Required

- KTC Trim Tool Set SOJATP2014
*

NOTE:

- Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.
- Take care not to scratch the cover.

Center

1. Remove the seat center pivot Third Row Seat Pivot Removal/Installation.

2. Remove the screws, then remove the center pivot cover brackets (A, B).






3. Remove the bolt, and separate both pivot bases (A, B), then remove the spring pin (C). Remove the pivot bolt (D), the pivot bracket (E), and the bushings (F, G) from the pivot base.





4. Reassemble the pivot in the reverse order of disassembly, and replace the spring pin and the bushings with new ones.

Outer

NOTE: The right side is shown; the left side is similar.

1. Remove the seat outer pivot Third Row Seat Pivot Removal/Installation.

2. Remove the cap (A) and the screws, then remove the upper bracket cover (B) and the lower bracket cover (C).






3. Remover the nut (A), then remover the pivot bracket (B), the bushings (C, D, E), the washer (F), and the spiral springs (G) from the pivot base (H).

NOTE: There are two spiral springs on the left side, and there are four spiral springs on the right side.





4. Reassemble the pivot in the reverse order of disassembly, and replace the bushings with new ones.