Third Row Seat-Back Recline Lever Replacement

Third Row Seat-Back Recline Lever Replacement

Special Tools Required

- KTC Trim Tool Set SOJATP2014
*Available through the Honda Tool and Equipment Program, 888-424-6857

NOTE:

- Put on gloves to protect your hands.
- Take care not to kink the seat-back recline cable.
- Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.
- When prying with a flat-tipped screwdriver, wrap it with protective tape to prevent damage.

1. Remove the left third row seat or the right third row seat Third Row Seat Removal/Installation.

2. Remove the seat-back cover.

3. While holding the lever (A) open, carefully pry out the cover (B) with a flat-tip screwdriver to release the tabs (C), then remove the cover.






4. Disconnect the recline cables (A).






5. Remove the screws, then remove the recline lever (A).






6. Install the lever in the reverse order of removal, and note these items:

- Make sure the recline cable is connected securely.
- Make sure the seat unlatches properly and latches securely.